Hi everyone.
When I import a file to be converted, D-O-M asks me the color space (in my case 709), then it converts into DCP. Question is: the DCP produced is a rec709-DCP or a P3-DCP? (i.e. does D-O-M convert automatically a 709 file into a P3-DCP?)
Thanks a lot
Rec.709-to-P3 under the hood?
-
Carsten
- Posts: 2804
- Joined: Tue Apr 15, 2014 9:11 pm
- Location: Germany
Re: Rec.709-to-P3 under the hood?
A DCP per definition is always XYZ color. DCP-o-matic does the necessary conversion if you use a supported content colorspace. rec.709 is supported, so all is well.
P3 is not the DCP colorspace, but an RGB display colorspace that is typically being used for DCP grading/mastering and cinema projection. Many people confuse XYZ and P3.
e.g.
source: rec.709
DCP: XYZ
DCI projector: P3
When the server plays a DCP, it will read XYZ from the DCP and usually convert XYZ to P3, then sends P3 to the projector.
- Carsten
P3 is not the DCP colorspace, but an RGB display colorspace that is typically being used for DCP grading/mastering and cinema projection. Many people confuse XYZ and P3.
e.g.
source: rec.709
DCP: XYZ
DCI projector: P3
When the server plays a DCP, it will read XYZ from the DCP and usually convert XYZ to P3, then sends P3 to the projector.
- Carsten
-
adrjork
- Posts: 2
- Joined: Sun Apr 29, 2018 4:36 pm
Re: Rec.709-to-P3 under the hood?
Finally a very clear answer! Thanks so much Carsten!